燃氣發電機常見故障

Common faults of gas generators

1. 啟動失?。嚎赡苁怯捎陔姵仉娏坎蛔?、點火系統故障、燃氣供應問題等導致。

1. Start failure: It may be caused by insufficient battery power, ignition system failure, gas supply issues, etc.

2. 燃氣發電機功率不足：可能是燃氣供應不足、空氣濾清器堵塞、渦輪增壓器故障等引起的。

2. Insufficient power of gas generator: may be caused by insufficient gas supply, clogged air filter, turbocharger failure, etc.

3. 排放超標：可能是燃燒不完全、燃料質量問題、排放控制裝置故障等造成的。

3. Emissions exceeding standards: may be caused by incomplete combustion, fuel quality issues, malfunction of emission control devices, etc.

4. 機械故障：如軸承磨損、齒輪損壞、振動過大等。

4. Mechanical faults: such as bearing wear, gear damage, excessive vibration, etc.

5. 電氣故障：如發電機繞組短路、斷路、勵磁系統故障等。

5. Electrical faults: such as generator winding short circuit, open circuit, excitation system failure, etc.

燃氣發電機常見故障的處理方法

Common troubleshooting methods for gas generators

1. 啟動失?。簷z查電池電量，更換電池或充電；檢查點火系統，清洗或更換點火電極；檢查燃氣供應系統，確保燃氣供應正常。

1. Startup failure: Check the battery level, replace the battery or charge it; Check the ignition system, clean or replace the ignition electrodes; Check the gas supply system to ensure normal gas supply.

2. 燃氣發電機功率不足：檢查燃氣供應壓力和流量，調整或更換燃氣閥門；清潔或更換空氣濾清器；檢查渦輪增壓器的工作狀態，必要時進行維修或更換。

2. Insufficient power of gas generator: Check the gas supply pressure and flow rate, adjust or replace the gas valve; Clean or replace the air filter; Check the working status of the turbocharger and repair or replace it if necessary.

3. 燃氣發電機排放超標：檢查燃燒室、噴油嘴和火花塞的清潔情況，進行清洗或更換；檢查燃料質量，使用合格燃料；檢查排放控制裝置

3. Gas generator emissions exceeding standards: Check the cleanliness of the combustion chamber, fuel injectors, and spark plugs, and clean or replace them; Check the quality of fuel and use qualified fuel; Check emission control devices

4. 機械故障：對軸承進行潤滑或更換；修理或更換損壞的齒輪；檢查機組安裝基礎，確保其平穩、牢固。

4. Mechanical failure: Lubrication or replacement of bearings; Repair or replace damaged gears; Check the installation foundation of the unit to ensure its stability and firmness.

5. 電氣故障：檢查發電機繞組絕緣情況，進行絕緣處理或更換繞組；檢查勵磁系統，修理或更換故障部件。

5. Electrical fault: Check the insulation condition of the generator winding, perform insulation treatment or replace the winding; Check the excitation system, repair or replace faulty components.

本文由燃氣發電機組配件友情奉獻.更多有關的知識請點擊:http://m.maryke8.com 真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

This article is a friendly contribution from the accessories of gas generator sets. For more related knowledge, please click: http://m.maryke8.com Sincere attitude. We will provide you with comprehensive service. We will gradually contribute more relevant knowledge to everyone. Stay tuned